Vox mini3 用户指南

This section describes the basic setup of your amplifier.
NOTE: This manual also describes safety precautions and

functions. Be sure to read the entire manual.

1.  Turn  the  MASTER  volume  on  the  amp  all  the  way

down.

2.  Install batteries in the amplifier. Alternatively, you can

connect the included AC adapter to the DC12V jack on

the rear panel, then plug the adapter into an AC outlet.

3.  Plug your guitar into the INPUT jack on the top panel. If

you also plan to use a CD or MP3 player, or a microphone,

connect the player to the AUX IN jack or the microphone

to the MIC IN jack on the top panel.

4.  Turn on the STANDBY switch.
5.  Slowly raise the MASTER volume to a desired level.

Remove the battery compartment cover located on the bot-

tom of the unit by pulling the ribbon. Insert six AA-size

alkaline batteries as shown in the figure. Be sure to observe

the correct polarity.
NOTE: Batteries are not included. You will need to purchase

them separately. Never use any type of battery other

than alkaline batteries.

NOTE: Be sure to install batteries in the correct orientation.

If the indicator located above and to the left of the STANDBY

switch becomes dark, replace the batteries.
NOTE: If the battery level becomes low, noise may be gener-

ated.

NOTE: Depleted batteries must be removed from the MINI3

immediately. If you leave them in, malfunctions such

as battery leakage may occur. You should also re-

move the batteries if you will not be using the MINI3

for an extended time.