GE zibi240pii 安装指导

*For a standard installation: The product must be installed so that

the stainless steel front will project 1-5/8" forward  of adjacent
cabinets. This position will allow a full door swing and prevent
interference with adjacent cabinetry. The opening between cabinets
must be 23-3/4" minimum.

**For a flush installation: Install a 1/4"-wide filler strip on the hinge

side. The filler strip will act as a spacer between the door case and
adjacent cabinets and will prevent interference with the cabinet
door swing. Recess the filler strip 1-5/8" back from the front face 
of the refrigerator, or even with the front edge of the product case
(behind the gasket). The width of the opening must be 24" (including
the 1/4" filler strip).

• All models may be used freestanding.

Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is

required. An individual properly grounded branch circuit
or circuit breaker is recommended. Install a properly
grounded 3-prong electrical receptacle recessed into
the back wall as shown. Electrical must be located on
rear wall as shown. NOTE: GFCI (ground fault circuit
interrupter) is not recommended.

NOTE:
Handle and
handle standoff
depth is 2-1/4".

NOTE:
Water line location
for ZIBS240 model
only

These products will fit flush to
adjacent cabinets when installed with
a 1/4" filler panel or cleat. The filler
panel should be recessed or set back
behind the door and even with the
front edge of the product case.

In a standard installation, the product 
will project forward of adjacent
cabinets. See Dim. A.

ZIFS240 1-5/8”
ZIBS240

2-5/8”

Filler panel or cleat to be set 
back even with front of case.

Front edge of product case

Front face

Front edge of product case

Front face

1/4"

110°

120°

CABINET

CABINET

CABINET

CABINET

110°

120°

Dim. A