GE tfx26ppd 用户手册
20
Customer Service
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service
Troubleshooting T
ips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service
Troubleshooting T
ips
Installation Instructions
Safety Instructions
Operating Instructions
Installing the water line.
Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the refrigera-
tor, be sure the refrigerator power
cord is not plugged into the wall outlet.
tor, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refrigerator’s water valve. Install it in
the water line near the refrigerator.
supply has sand or particles that could clog the
screen of the refrigerator’s water valve. Install it in
the water line near the refrigerator.
Remove the plastic flexible cap from the water
valve (refrigerator connection).
valve (refrigerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
onto the end of the tubing as shown.
Insert the end of the copper tubing into
the water valve refrigerator connection as far
as possible. While holding the tubing, tighten
the fitting.
the water valve refrigerator connection as far
as possible. While holding the tubing, tighten
the fitting.
Fasten the copper tubing into the clamp provid-
ed to hold it in position. You may
need to pry open the clamp.
ed to hold it in position. You may
need to pry open the clamp.
One of the illustrations below will look like the connection
on your refrigerator.
on your refrigerator.
4
3
2
1
Turn the Water On at the Shutoff Valve
Tighten any connections that leak.
Replace the access cover and screws (on some
models).
models).
2
1
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall.
vibrate against the back of the refrigerator or against
the wall.
Push the refrigerator back to the wall.
Start the Icemaker
Set the icemaker feeler arm to the ON (down) posi-
tion. The icemaker will not begin to operate until it
reaches its operating temperature of 15°F
(-9°C) or below. It will then begin operation auto-
matically if the icemaker feeler arm is in the
ON (down) position.
tion. The icemaker will not begin to operate until it
reaches its operating temperature of 15°F
(-9°C) or below. It will then begin operation auto-
matically if the icemaker feeler arm is in the
ON (down) position.
NOTE: The icemaker may double-cycle when it first starts,
causing some water spillage from the icemaker into the
ice bucket. This is normal and should not happen again.
causing some water spillage from the icemaker into the
ice bucket. This is normal and should not happen again.
1/4
″
Compression
Nut
Nut
1/4
″
Copper
Tubing
Remove screws
and fold back
access cover.
and fold back
access cover.
Ferrule
(sleeve)
(sleeve)
Tubing Clamp
Refrigerator
Connection
Connection
OR
1/4
″
Compression Nut
1/4
″
Copper
Tubing
Ferrule (sleeve)
Tubing Clamp
Refrigerator
Connection
Connection