Fargo dtc300 用户指南

RESTRICTED USE ONLY

Fargo Electronics, Inc.

DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)

3-1

Section 3: Setup and Installation
Procedures

The following guide will walk you through the installation of the DTC300/DTC300M Card
Printer Driver.



Time Requirement (software): This software installation process will require

approximately 2 to 5 minutes (depending on the speed of your PC).



Time Requirement (Printer): The time required to set up a standard DTC300/DTC300M

Printer would be approximately 5 to 10 minutes.

The System Requirements are as follows:

IBM-PC or compatible, Windows

98SE, Me/2000/XP, Pentium

class 233MHz computer

with 64MB of RAM or higher, 200MB free hard disk space or higher, USB 1.1

Table of Contents

Section 3: Setup and Installation Procedures ___________________________________ 3-1

Table of Contents ___________________________________________________________________ 3-1

Printer Setup and Installation __________________________________________________________ 3-3

Choosing A Good Location _________________________________________________________ 3-3

About Moisture Condensation _______________________________________________________ 3-3

Unpacking and Inspection __________________________________________________________ 3-4

Reviewing the Printer (front view) ____________________________________________________ 3-5

Reviewing the Printer (front view; Cartridge being installed) _______________________________ 3-5

Reviewing the LCD (top-front part of Printer) ___________________________________________ 3-6

Connecting the Printer power ________________________________________________________ 3-7

Installing the Print Ribbon Cartridge __________________________________________________ 3-8

Installing the Print Ribbon Cartridge (continued) ______________________________________ 3-9

Installing the Print Ribbon Cartridge (continued) _____________________________________ 3-10

Installing Blank Cards into the Card Hopper ___________________________________________ 3-11

Installing Blank Cards into the Card Hopper (continued) _______________________________ 3-12

Installing Blank Cards into the Card Hopper (continued) _______________________________ 3-13

Lowering the Card Output Hopper ___________________________________________________ 3-14

Flipper Table Module Installation ______________________________________________________ 3-15

Installing the Flipper Table Module Assembly (D900200) ________________________________ 3-15

Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 3-16

Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 3-17

Printer Driver Installation ____________________________________________________________ 3-18

Installing the Printer Driver ________________________________________________________ 3-18

Installing the Printer Driver (continued) ____________________________________________ 3-19

Installing the Printer Driver (continued) ____________________________________________ 3-20

Installing the Printer Driver (continued) ____________________________________________ 3-21

Installing the Printer Driver (continued) ____________________________________________ 3-22

Installing the Printer Driver (continued) ____________________________________________ 3-23

Installing the Printer Driver (continued) ____________________________________________ 3-24

Installing the Printer Driver (continued) ____________________________________________ 3-25

Installing the Printer Driver (continued) ____________________________________________ 3-26

Installing the Printer Driver (continued) ____________________________________________ 3-27

Installing the Printer Driver (continued) ____________________________________________ 3-28

Installing the Printer Driver (continued) ____________________________________________ 3-29

Printing a Test Print Image _________________________________________________________ 3-30