Konica Minolta Z10 说明手册

下载
页码 120
27
If the shutter speed falls below the point where the camera
can be safely hand held, the camera-shake warning appears
on the LCD monitor. Camera shake is slight blurring caused
by  subtle  hand  motion  and  is  more  pronounced  at  the
telephoto  position  of  the  lens  than  at  the  wide-angle.
Although  the  warning  appears,  the  shutter  can  still  be
released.  If  the  warning  appears,  place  the  camera  on  a
tripod,  use  the  built-in  flash,  or  zoom  the  lens  towards  the
wide-angle position until the warning disappears. 
CAMERA-SHAKE WARNING
FLASH RANGE - AUTO-RECORDING MODE
The camera controls the flash output automatically.
For  well-exposed  images,  the  subject  must  be
within  the  flash  range.  Distance  is  given  from  the
CCD  plane.  Because  of  the  optical  system,  the
flash range is not the same at the lens’ wide-angle
position as it is at the telephoto position.
Approximate location of CCD plane
Camera-shake warning
If  the  flash  output  was  sufficient  to  illuminate  the  subject,  the  OK  indicator  briefly
replaces  the  flash-mode  indicator  after  the  exposure.  The  access  lamp  turns  red  and
blinks  slowly  while  the  flash  is  charging;  if  battery  power  is  low,  the  monitor  turns  off
during this period.
If using continuous AF or the sports action subject program with flash, the monitor image
reflects  the  exposure  required  for  the  flash  when  the  shutter-release  button  is  pressed
partway down. This may cause the monitor image to appear dark in low-light situations.
Camera Notes
Wide-angle position
0.57 - 5.3m (1.87 - 17.39 ft)
Telephoto position
1.57 - 5.3m (5.15 - 17.39 ft)