Konica Minolta dimage xg 用户手册

Pictures are
not sharp.

Focus signal
is red.

Subject is too close.

Make sure the subject is within
the autofocus range (p. 30).

A special situation is pre-
venting the autofocus sys-
tem from focusing (p. 31).

Use the focus-lock function to
focus on an object at the same
distance as the subject (p. 30).

Pictures are
taken indoors
or in low-light
situations
without flash.

Slow shutter speeds result
in blurred images when the
camera is hand-held.

Use a tripod, change the camera
sensitivity to a higher setting (p.
52), or use the flash (p. 32).

While using
flash, the pic-
tures are too
dark.

The subject is beyond the flash range (p.
33).

Move closer to the subject or
change the camera sensitivity to
a higher setting (p. 52).

Subject
appears too
far to the right
in the image.

Viewfinder was used for framing. Parallax is
apparent with subjects closer than 1m (3ft.)
at the zoom’s wide-angle position or 3m
(10ft) at the telephoto position. 

Use only the LCD monitor for
framing with close subjects.

Part of the
image area is
hidden behind
a dark object.

Viewfinder
was used to
capture the
image.

The lens was partially cov-
ered with an object or fin-
ger. 

When using the viewfinder, take
care not to cover the lens.

If the camera does not function normally, turn it off, remove and reinsert the battery, or unplug and
reconnect the AC adapter set. Always turn the camera off using the main switch otherwise the
memory card may be damaged and camera settings reset.