Hitachi DZ-MV580A 用户手册

下载
页码 187
English
34
Using Remote Control
Point the remote control to the infrared receiver on the DVD video camera/recorder. The remote 
controllable distance is up to 16 feet (5 m).
Note
:
When using the remote control, make sure that the 
infrared receiver on DVD video camera/recorder is not 
exposed to direct sunlight or any intense light. If the 
infrared receiver is subject to light stronger than the 
infrared light from remote control, the DVD video 
camera/recorder cannot be operated by remote control.
If there is an obstacle between the remote control and 
infrared receiver on DVD video camera/recorder, 
remote control may not be possible.
The DVD video camera/recorder uses the “VCR2” 
remote control code of Hitachi VCRs. If you use a Hitachi 
VCR, etc. with remote control code set to “VCR2”, a VCR 
placed near the DVD video camera/recorder will also be 
operated by the remote control: To prevent this, change 
the remote control code of the VCR.
VIEWING SUBJECT THROUGH VIEWFINDER
1
Pull out the viewfinder.
2
Turn the diopter control knob to adjust the 
focus to suit your eyesight.
Note
:
If no image appears in viewfinder, refer to “Check 6” on 
page 164.
If the LCD monitor is open approximately 90°, the 
viewfinder will be off.
Focusing will not be correct unless the viewfinder is 
pulled out.
10˚
10˚
15˚
15˚
Ap
pr
ox
. 1
fe
et
 (5
m
)
Infrared receiver
Diopter control
Pull out the finder until a 
click is heard.
Viewfinder