Hitachi c10ra3 electric table saw 用户手册

–  5  – 

1.  ALWAYS USE SAW BLADE GUARD, splitter and 

anti-kickback pawls for every through

–sawing 

operation. Through

–sawing operations are those 

in which the blade cuts completely through the 
workpiece when ripping or crosscutting. Always be 
sure blade guard is tightened securely. 

2.  ALWAYS HOLD WORK FIRMLY against the miter 

gauge or rip fence.

3.  ALWAYS USE a push stick, especially when ripping 

narrow stock.  Refer to ripping instructions in this 
Operator’s Manual where the push stick is covered 
in detail. A pattern for making your own push stick is 
included on page 24.

4. 

5.  NEVER STAND or have any part of your body in line 

with the path of the saw blade. Keep your hands out 
of the saw blade path.

6.  NEVER REACH behind or over the cutting tool for 

any reason.

7.  REMOVE the rip fence when crosscutting.

8.  DO NOT USE a molding head with this saw.

9.  FEED WORK INTO THE BLADE against the 

direction of rotation only.

10. NEVER use the rip fence as a cut-off gauge when 

crosscutting.

11. NEVER ATTEMPT TO FREE A STALLED SAW 

BLADE without fi rst turning the saw OFF. Turn 
power switch OFF immediately to prevent motor 
damage.

12. PROVIDE ADEQUATE SUPPORT to the rear  

and the sides of the saw table for long or wide 
workpieces.

13. AVOID KICKBACKS (work thrown back towards you) 

by keeping the blade sharp, the rip fence     parallel 
to the saw blade and by keeping the splitter, anti-
kickback pawls and guards in place, aligned and 
functioning. Do not release work before passing it 
completely beyond the saw blade. Do not rip work 
that is twisted, warped or does not have a straight 
edge to guide it along the fence. 

14. AVOID AWKWARD OPERATIONS and hand      

positions where a sudden slip could cause your 
hand to move into the saw blade.

15. NEVER USE SOLVENTS to clean plastic parts.      

Solvents could possibly dissolve or otherwise      
damage the material. Only a soft damp cloth should 
be used to clean plastic parts.

16. MOUNT your table saw on a bench or stand 

before performing any cutting operations. Refer to     
ASSEMBLY AND ADJUSTMENTS on page 11.

17. NEVER CUT METALS or materials that may make 

hazardous dust.

18. ALWAYS USE IN A WELL-VENTILATED AREA.      

Remove sawdust frequently. Clean out sawdust 
from the interior of the saw to prevent a potential 
fi re hazard. Attach a vacuum to the dust port for      
additional sawdust removal.

19. NEVER LEAVE THE SAW RUNNING      

UNATTENDED. Do not leave the saw until the blade 
comes to a complete stop.

20. For proper operation follow the instructions in 

this Operator’s Manual entitled ASSEMBLY AND 
ADJUSTMENTS (Page 11). Failure to provide 
sawdust fall-through and removal hole will allow 
sawdust to build up in the motor area resulting in a 
fi re hazard and potential motor damage.