Hitachi BZ-1 用户指南

67

NETWORK menu

Remember that incorrect network settings on this 
projector may cause trouble on the network. Be sure 
to consult with your network administrator before 
connecting to an existing access point on your network.
Select “NETWORK” from the main menu to access 
the following functions. 
Select an item using the ▲/▼ cursor buttons on the 
projector or remote control, and press the ► cursor button on the projector or 
remote control, or ENTER button on the remote control to execute the item. Then 
perform it according to the following table.
See the User’s Manual - Network Guide for details of NETWORK operation.

NETWORK menu

• If you are not utilizing SNTP (

Date/Time Settings in the User’s 

Manual - Network Guide), then you must set the DATE AND TIME during the 
initial installation.
• The network communication control is disabled while the projector is in 
standby mode if the STANDBY MODE item of SETUP menu is set to SAVING. 
Please connect the network communication to the projector after setting the 
STANDBY MODE to NORMAL (

47).

• Performance may suffer if the image displayed from the LAN Port is used 
while using Interactive Function. It is recommended to use COMPUTER IN or 
HDMI connection.

NOTE

Selecting this item displays the SETUP 
Menu for the network.
Use the ▲/▼ buttons to select an item, 
and the ► or ENTER button on the remote 
control to perform the item.

Use the ▲/▼ buttons to turn DHCP on/off.

ON 

 OFF

Select OFF when the network does not have 
DHCP enabled.

• When the “DHCP” setting changes to “ON”, it 
takes a little time to obtain IP address from DHCP 
server.
• Auto IP function will be assigned an IP address if 
the projector could not obtain an IP address from 
server even if DHCP is “ON”.

(continued on next page)