Hitachi 22gxp 安装指导

15 

The following steps install the IBM Deskstar as the Primary Slave in a system with an existing 
drive as Primary Master. 
 
Begin the hardware install  

 

1. 

Turn off your computer system. 

2. 

Remove the cover as instructed by your computer system 
manual. 

3. 

Discharge static electricity by touching an unpainted metal 
surface on your computer chassis with one hand.  Touch the 
ESD bag with the other hand. Remain in contact with the 
chassis and the bag for at least two seconds. 

4. 

Unplug your computer.   

5. 

Note the mounting position of existing drives and cables. 

6. 

If replacing a drive or replacing a cable with a 40-pin, 80-
conductor ATA/IDE cable, remove it.  Store the drive in a safe 
place in case it should be needed again. 

 
 
Configure the jumper settings 
 

1. 

Remove the drive from the ESD bag.   

2. 

Record the serial number, part number, and model number on a separate sheet of paper for future 
reference.   

 

 

 

Note: Placement of model, part, and serial numbers may vary.