Hitachi 22gxp 安装指导

5 

The following steps install the IBM Deskstar as the only drive in a system without a Windows 
operating system.  
 
Begin the hardware install 
 

1. 

Turn off your computer system. 

2. 

Remove cover as instructed by your computer system manual. 

3. 

Discharge static electricity by touching an unpainted metal 
surface on your computer chassis with one hand.  Touch the 
ESD bag with the other hand.  Remain in contact with the 
chassis and the bag for at least two seconds. 

4. 

Unplug your computer.   

5. 

If replacing a drive or replacing a cable with a 40-pin, 80-
conductor ATA/IDE cable, remove it.  Store the drive or cable 
in a safe place in case it should be needed again. 

 
 
Configure the jumper settings 
 

1. 

Remove the drive from its ESD bag.   

2. 

Record the serial number, part number, and model number on a separate sheet of paper for future 
reference.