Hitachi 3k6 安装指导

Page 

1 

         version 

1.0 

 

Quick Installation Guide

•  Follow these suggestions to optimize the use of 

your Hitachi Microdrive, as well as those 
devices in which it is installed: 

•  Do not seal the breather hole!  Sealing the 

breather hole may result in loss of data. 

•  Do not press on the drive!  Do not apply any 

force to the drive during handling or installation. 

•  Always handle the drive with care to prevent 

damage from shock, vibration, or electrostatic 
discharge (ESD). 

•  Handle the drive carefully by the edges.  Do not 

touch any exposed printed circuit board.   

•  Do not write on the label or remove it.  Do not 

apply additional labels. 

•  Always carry the drive in its plastic case. 

•  Do not drop the drive. 

•  Do not expose the drive to wet conditions. 

•  Do not place the drive near a strong magnetic 

field. 

•  Do not expose the drive to extreme tempera-

tures. 

•  Do not use the drive in CF+

TM

 Type II slots 

without an ejection mechanism. 

•  The Microdrive may become hot during opera-

tion.  Be careful when removing the drive from 
the host device immediately after operation. 

Note: Back up all data before beginning installation! 

Refer to the manual that came with your computer, 
camera, or other device to determine if it is compatible 
with the CF+ Type II or the PC card type II drive/inter-
face adapter and to find instructions on inserting and 
removing the Hitachi Microdrive.

 

y 

Using the Hitachi Microdrive with a PC card adapter 

With a PC card adapter the Hitachi Microdrive can be 
installed in devices such as digital cameras or PCs that 
have a PC card type II slot.  If your Microdrive did not 
come with a PC card, it can be purchased separately. 

With both facing upward (the arrow at the upper left 
corner of the Microdrive), slide the Hitachi Microdrive 
firmly along the track into the PC card adapter.  [If either 
is not facing upward, the Microdrive will not fit into the 
track.]   

Note: When inserting or removing the PC card, hold the 
PC card, not the Hitachi Microdrive. 

y 

Using the Hitachi Microdrive without a PC card 
adapter 

The Hitachi Microdrive is compatible with the CF+ Type 
II standard and can be used in devices with the CF+ 
Type II slot without a card adapter.  Refer to the manual 
shipped with the device to determine its slot type. 

If your PC does not recognize the Hitachi 
Microdrive 
With the Plug & Play feature of Windows® XP and 2000 
your PC should automatically recognize the Hitachi 
Microdrive.  If it does not do so, do the following: 

1.  In Windows select Start and Settings. 
2.  Click Control Panel. 
3.  Click the Hardware icon, click Next. 
4.  Select No in the Hardware Wizard, click Next. 
5.  Select Hard disk controller as the hardware type, 
 click 

Next. 

6.  Specify Standard IDE/ESDI hard disk controller 

Models: HMS360606D5CF00

HMS360604D5CF00
HMS300603D5CF00