Hitachi c4k60 安装指导
Hitachi Global Storage Technologies
Page
2
version
1.0
Mounting Recommendations
•
There are no screw holes in the Travelstar C4K60 Slim hard disk drive. Hitachi
recommends you secure the drive by placing it in a case as shown in the
diagram below. Hitachi GST will assist customers with mounting design.
recommends you secure the drive by placing it in a case as shown in the
diagram below. Hitachi GST will assist customers with mounting design.
•
The temperature of the center of the hard drive cover should remain less than 65°C at all times.
•
The inertia of the chassis around the Z-axis of the gravity center of the device must be more than 3 x
10
10
-4
kg m
2.
•
In case of general Sub-notebook PC weight (1.7kg), the inertia of the chassis around the Z-axis of the
gravity center of the device is greater than 100 x 10
gravity center of the device is greater than 100 x 10
-4
kg m
2
. Therefore, the required inertia level does
not conflict with the general electronic equipment.
•
If installing the C4K60 next to a steel plate, the cover of the C4K60 and the steel plate must have at
least 2mm of space between them. This is necessary for air flow and cooling requirements.
least 2mm of space between them. This is necessary for air flow and cooling requirements.
•
The PCBA side of the drive should be covered with insulation if it is in contact with any metal part of
the host system. Contact between the PCBA and metal may result in drive failure.
the host system. Contact between the PCBA and metal may result in drive failure.
•
The blue frame shown below represents the casing used when the drive can not be secured with screws.