Clavia lead 3 用户指南
NORD LEAD 3 V1.2x
7. Panel reference: Modulation Envelope
Page 51
If Attack and Decay are both used and you have a positive Amount setting, the sound will start at normal
pitch when you press the key, rise to maximum Amount and then fall back to the initial pitch.
pitch when you press the key, rise to maximum Amount and then fall back to the initial pitch.
FILTER (1
FILTER (1
FILTER (1
FILTER (1
A
A
A
AN
N
N
ND
D
D
D
////
O
O
O
OR
R
R
R
2)
2)
2)
2)
This routes the Modulation Envelope to the Filter Frequency1 and/or 2 parameters. This can for example
be used for sweeping filter effects and for auto repeating sounds (in Repeat mode described below).
be used for sweeping filter effects and for auto repeating sounds (in Repeat mode described below).
SHAPE (1
SHAPE (1
SHAPE (1
SHAPE (1
A
A
A
AN
N
N
ND
D
D
D
////
O
O
O
OR
R
R
R
2)
2)
2)
2)
This routes the Modulation Envelope to the Shape amount of Oscillator 1 and/or 2. The Shape could
be, for example, Pulse Width, FM amount or Oscillator Sync. Please refer to
be, for example, Pulse Width, FM amount or Oscillator Sync. Please refer to
for details about
Shape.
OSCMOD
OSCMOD
OSCMOD
OSCMOD
This routes the Modulation Envelope to the Oscillator Modulation Amount. The Oscillator Modulation
could be, for example, FM, Distortion, FilterFM etc. Please refer to
This routes the Modulation Envelope to the Oscillator Modulation Amount. The Oscillator Modulation
could be, for example, FM, Distortion, FilterFM etc. Please refer to
for details about Oscillator
Modulation.
OSCMIX
OSCMIX
OSCMIX
OSCMIX
This routes the Modulation Envelope to the Oscillator Mixer.
This routes the Modulation Envelope to the Oscillator Mixer.
LFO1
LFO1
LFO1
LFO1
This routes the Modulation Envelope to the LFO1 Amount parameter. This can for example be used for
slowly introducing the LFO1 modulation. To make the LFO1 Amount remain at a certain level when
you hold down a key, set the Modulation Envelope in Attack/Release mode (see above).
This routes the Modulation Envelope to the LFO1 Amount parameter. This can for example be used for
slowly introducing the LFO1 modulation. To make the LFO1 Amount remain at a certain level when
you hold down a key, set the Modulation Envelope in Attack/Release mode (see above).
A
A
A
A
M
M
M
MO
O
O
OU
U
U
UN
N
N
NT
T
T
T
Set to what degree the Modulation Envelope should affect the destination. The modulation amount can
be either positive or inverted. To switch to inverted amount, hold down S
be either positive or inverted. To switch to inverted amount, hold down S
HIFT
and turn the A
MOUNT
knob clockwise. To revert to positive modulation, hold down S
HIFT
and turn the A
MOUNT
knob coun-
ter-clockwise. Note that the Mod Envelope modulation can be different depending on the selected des-
tination and modulation mode. See
tination and modulation mode. See
.