Canon MP730 安装指导
3
Raise the lock lever C, then gently slide the printhead into the holder.
Lower the lock lever.
Lower the lock lever.
IMPORTANT
• Do not lift the lock lever once the printhead has been installed.
Install the ink tanks.
1
Start with the yellow ink tank. Pull the orange tape in the direction of the arrow
and remove the plastic wrapper so you can see the air hole A. Turn the ink tank
over so that the protective cap B is facing up. Then hold the ink tank as shown
below and remove the protective cap B.
and remove the plastic wrapper so you can see the air hole A. Turn the ink tank
over so that the protective cap B is facing up. Then hold the ink tank as shown
below and remove the protective cap B.
NOTE
• To avoid spilling ink, never
press on the long sides of
the ink tank C.
the ink tank C.
• Once you remove the
protective cap B, do not
touch the ink port D.
touch the ink port D.
2
Insert the ink tank (label-side up) into the correct slot (refer to the color guide on
the printhead). Press down gently on the ink tank until an audible click is heard.
the printhead). Press down gently on the ink tank until an audible click is heard.
3
Repeat steps 1 and 2 to install the remaining magenta, cyan, and black ink tanks.
IMPORTANT
• Make sure the ink tanks are inserted
all the way into their slots.
4
Close the scanning unit until it locks into place.
Align the printhead as explained in step 10.
Align the printhead as explained in step 10.
Black
Yellow
Magenta
Cian
Black
BCI-3eC
BCI-3eBK
BCI-3eM
BCI-3eY
Yellow
Magenta
Cian
PUSH
PUSH
PUSH
PUSH
Black
Black
BCI-3
eC
BCI-3
eBK
BCI-3
eM
BCI-3
eY
Yellow
Mage
nta
Cian
PUSH
PUSH
PUSH
Black
PUSH
Yello
w
Mage
nta
Cian
Black
Correct position
Incorrect position
Black
Yellow
Magenta
Cian
Black
BCI-3eY
Yellow
PUSH
Black
Yello
w
Magenta
Cian
Black
BCI-
3eY
Yello
w
PUS
H
PU
SU
Ye
llow
Ma
de
in
Ja
pa
n
Ink Tank
BC
I-3
eY
PU
LL
PU
LL
BCI-3eY
Ink Tank
A
B
B
D
C
C