LXE hx3 参考指南
Summit Client Configuration
171
E-EQ-HX3RG-C
HX3 Reference Guide
Status Tab
This screen displays information on the current profile and wireless connection. Information
cannot be edited or changed on the Status panel.
cannot be edited or changed on the Status panel.
Figure 5-6 SCU – Status Tab
The panel displays:
• Config / Profile being used.
• The client name, IP address and MAC address.
• The status of the network connection (down, associated, authenticated, etc.).
• The name, IP address and MAC address of the Access Point maintaining the
• The client name, IP address and MAC address.
• The status of the network connection (down, associated, authenticated, etc.).
• The name, IP address and MAC address of the Access Point maintaining the
connection to the network.
• Channel currently being used for wireless traffic.
• Beacon period – The time between AP beacons in kilomicroseconds (1
• Beacon period – The time between AP beacons in kilomicroseconds (1
kilomicrosecond = 1,024 microseconds).
• DTIM interval – A multiple of the beacon period that specifies how often the beacon
contains a delivery traffic indication message (DTIM). The DTIM tells power saving
devices a packet is waiting for them. For example, if DTIM = 3, then every third
beacon contains a DTIM.
devices a packet is waiting for them. For example, if DTIM = 3, then every third
beacon contains a DTIM.
• Current transmit power in mW.
• Rate in Mbps.
• Signal strength (RSSI) and signal quality (changes with network activity). Signal
• Rate in Mbps.
• Signal strength (RSSI) and signal quality (changes with network activity). Signal
quality is a measure of the clarity of the signal and is displayed as a percentage.
Note:
After completing radio configuration, it is good practice to review this screen to verify
the radio has associated (no encryption, WEP) or authenticated (LEAP, any WPA), as
indicated above.
the radio has associated (no encryption, WEP) or authenticated (LEAP, any WPA), as
indicated above.