LXE hx3 参考指南
6
Getting Started
HX3 Reference Guide
E-EQ-HX3RG-C
Quick Start Troubleshooting
HX3 seems to lockup
as soon as it is warm
booted.
as soon as it is warm
booted.
There may be slight delays while the wireless client connects to the
network, authorization for voice-enabled applications complete,
Wavelink Avalanche management of the HX3 startup completes,
and Bluetooth relationships establish or re-establish. When the
status LED flashes green the OS has loaded. When the Wireless
LED is solid yellow a wireless connection has been established.
network, authorization for voice-enabled applications complete,
Wavelink Avalanche management of the HX3 startup completes,
and Bluetooth relationships establish or re-establish. When the
status LED flashes green the OS has loaded. When the Wireless
LED is solid yellow a wireless connection has been established.
Setup the Client and Network
Prerequisites
• Network SSID or ESSID number of the Access Point
• WEP or LEAP Authentication Protocol Keys
• WEP or LEAP Authentication Protocol Keys
See Chapter 5 Wireless Network Configuration for complete information.
Saving Settings to the Registry
Some of the options in this section require an ActiveSync connection and
LXEConnect. Please see “ActiveSync and the HX3” in Chapter 3 System
Configuration for details on establishing this connection.
LXEConnect. Please see “ActiveSync and the HX3” in Chapter 3 System
Configuration for details on establishing this connection.
The HX3 saves the registry when you:
• Tap Start | Run | then type Warmboot. Tap OK.
• Perform a Suspend / Resume function (by tapping the Power key and then tapping it
• Perform a Suspend / Resume function (by tapping the Power key and then tapping it
again).
• Install Restart in the Start menu by Start | Run | then type CTL RESTART=1 and tap
the OK button. Tap Start | Restart.
Note:
Using any of these methods to save the registry ends the HX3 ActiveSync connection. To
make additional changes, it is necessary to reestablish the ActiveSync connection by
unhooking the USB end of the cable from the PC and then reinserting the cable.
make additional changes, it is necessary to reestablish the ActiveSync connection by
unhooking the USB end of the cable from the PC and then reinserting the cable.
The registry save process takes 0 – 3 seconds. If nothing has been changed, nothing is saved (e.g.
0 seconds)
0 seconds)
The registry is automatically saved every 20 minutes. It is also saved every tenth time the registry
settings are changed. Registry settings are changed when control panel applet (e.g. Date/Time)
parameters are changed by the user and a warm boot was not performed afterward.
settings are changed. Registry settings are changed when control panel applet (e.g. Date/Time)
parameters are changed by the user and a warm boot was not performed afterward.
When you tap the Start | Run | then type Coldboot and tap the OK button, factory default registry
settings are loaded during coldboot. All user changes and settings are lost.
settings are loaded during coldboot. All user changes and settings are lost.