Viking Range dmod240ss 安装指导

E3

to reduce the risk of tipping of the drawer, the anti-tip

block must be properly installed located 14

13

/

16

" above

the floor on which the appliance will sit. the 6" anti-tip

block must be provided by the installer. see fIgure 1.

the anti-tip block prevents serious injury that might result

from spilled hot liquids.
If  the  drawermicro  oven  is  ever  moved  to  a  different

location,  the  anti-tip  block  must  also  be  moved  and

installed. when installed to the wall, make sure that the

screws completely penetrate the dry wall and are secured

in wood or metal so that the block is totally stable. when

fastening,  be  sure  that  the  screws  do  not  penetrate

electrical wiring or plumbing.

4"

(101.6 mm)

5"

(127 mm)

Electrical Outlet

Location

Anti-tip

Block

6"

(153 mm)

the  electrical  requirements  are  a  120  volt  60  hz,  ac

only, 15 amp. or more protected electrical supply. It is

recommended  that  a  separate  circuit  serving  only  this

appliance be provided.
the appliance is equipped with a 3-prong grounding plug.

It must be plugged into a wall receptacle that is properly

installed and grounded. should you only have a 2-prong

outlet, have a qualified electrician install a correct wall

receptacle.
note:
If you have any questions about the grounding or electrical

instructions,  consult  a  qualified  electrician  or  service

person.

1. place the drawermicro oven adjacent to the wall or

cabinet opening. plug the power supply cord into the

electrical outlet.

2. carefully  guide  the  appliance  into  the  prepared

opening. avoid pinching the cord between the oven

and the wall.

3. slide the drawer all the way until the mounting flange

is flush with the face of the cabinet. see fIgure 5a.

4. open the drawer. using the 4 holes on the drawer as

a template, pre drill the cabinet using a

1

/

16

" bit. see

fIgure 5a.

5. secure  the  drawer  with  the  4  screws  supplied.  see

fIgure 5b.

4 Screws

4"

(101.6 mm)

5"

(127 mm)

Electrical Outlet

Location

Anti-tip

Block

6"

(153 mm)

Mounting

Flange