Ricoh 1027 软件指南
Monitoring and Configuring the Printer
200
❖ Protocol settings
msh> smb protocol [netbeui {up | down} | tcpip {up | down}]
• Enable or disable NetBEUI and TCP/IP. Specify “up” to enable, and “down”
to disable.
snmp
Use the “snmp” command to display and edit SNMP configuration settings such
as the community name.
as the community name.
❖ View settings
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IP address:0.0.0.0
Access type:read-only / trap off
IP address:0.0.0.0
Access type:read-only / trap off
• Default access settings 2 is as follows:
Community name:admin
IP address:0.0.0.0
Access type:read-write / trap off
IP address:0.0.0.0
Access type:read-write / trap off
• If “-p” is added, you can view settings one by one.
• To display the current community, specify its registration number.
❖ Display
msh> snmp ?
❖ Community name configuration
msh> snmp “number” name “community_name”
• You can configure ten SNMP access settings numbered 1-10.
• The printer cannot be accessed from SmartDeviceMonitor for Admin or
SmartDeviceMonitor for Client if “public” is not registered in numbers 1-10.
When changing the community name, use SmartDeviceMonitor for Admin
and SNMP Setup Tool to correspond with printer settings.
When changing the community name, use SmartDeviceMonitor for Admin
and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
❖ Deleting community name
msh> snmp “number” clear name
❖ Access type configuration
msh> snmp “number” type “access_type”
Access type
Type of access permission
no
not accessible