Ricoh 240w 用户指南
DRAFT 2003/11/12
Troubleshooting
76
3
Copies shift in the direction of
the original feed (or opposite)
direction.
the original feed (or opposite)
direction.
Shift or Margin Adjustment
mode is selected.
mode is selected.
Copies are shorter than the se-
lected size, or cut off before
the end.
lected size, or cut off before
the end.
Wrinkles appear on the copy.
The paper is damp.
Replace the paper with new
paper.
paper.
Cut the paper to 1000 mm
(40") just before copying.
(40") just before copying.
The paper is damp. See “Anti-
humidity Heater Switch”,
General Settings Guide.
humidity Heater Switch”,
General Settings Guide.
Turn on the anti-humidity
heater. See “Anti-humidity
Heater Switch”, General Set-
tings Guide.
heater. See “Anti-humidity
Heater Switch”, General Set-
tings Guide.
Copies are slanted.
The original is not straight.
Insert the original along the
original guides, so it is
straight.
original guides, so it is
straight.
Original and copy size does
not match.
not match.
Dampness can cause paper to
stretch.
stretch.
Adjust the Fine Magnification
setting for Additional Copy.
See p.21 “Fine Directional
Magnification (Additional
Copies Only)”.
setting for Additional Copy.
See p.21 “Fine Directional
Magnification (Additional
Copies Only)”.
Adjust the Fine Magnification
setting. See “Fine Ratio:Copi-
er”, General Settings Guide.
setting. See “Fine Ratio:Copi-
er”, General Settings Guide.
You cannot combine several
functions.
functions.
The selected functions cannot
be used together.
be used together.
Check the combination of set-
tings, and set again. See p.104
“Combination Chart”.
tings, and set again. See p.104
“Combination Chart”.
Problem
Causes
Solutions