Ricoh 480W 参考指南
JOB
EDITOR
respective HPGL or CalComp tabs via the "pen settings..."
button.
button.
View the changes
RW-480 PLOTBASE has an additional function, which allows
you to look at the changes to the pen widths and some of the
pen colors before printing in the File Viewer, if changes have
been made to a certain entry. To do this, proceed as follows:
pen colors before printing in the File Viewer, if changes have
been made to a certain entry. To do this, proceed as follows:
1. Activate the view using the "View - File Viewer" menu item.
2. Mark an entry in the entry list.
2. Mark an entry in the entry list.
3. In the job editor change to the "Additional" tab and open
the "Pen Settings".
4. Make your changes.
5. Now change to the "Misc" tab and activate the pen source
as "Custom".
6. Quit the pen settings.
7. Select the entry which has just been changed. The changes
can be seen in the file view. Remember that you may have
to change the view, for example if you want to recognize a
to change the view, for example if you want to recognize a
slight change in the pen thickness.
Note: It is possible that if you change colors you will
not see any large changes in the File Viewer, for
example when you only change from 50% grey to 60%
grey. Clear changes are e.g. visible if you set the color
of all pens to "white", but then you don’t have to print
the drawing either!
grey. Clear changes are e.g. visible if you set the color
of all pens to "white", but then you don’t have to print
the drawing either!
HPGL and HPGL/2 pen settings
You can stipulate numerous pen attributes in the cards which
are saved in an HPGL configuration file (*.hcf).
To create a new configuration file, adjust the settings in the
cards and press "OK" to save them. You can save certain special
To create a new configuration file, adjust the settings in the
cards and press "OK" to save them. You can save certain special
RW-480 PLOTBASE 118