Ricoh ap2600 用户指南
Other Printing Problems
79
5
Other Printing Problems
Status
Possible Causes, Descriptions, and Solutions
The print side of the page is a
hazy gray.
hazy gray.
Adjust the image density.
If paper is curled, correct it.
Check if the size selected with the paper tray dial matches that
selected with the operation panel. If not, select the correct size
that matches the size and feed direction loaded in the tray.
If you print something after printing on the paper whose size
is smaller than the actual document size, the back of the next
output might get dirty.
selected with the operation panel. If not, select the correct size
that matches the size and feed direction loaded in the tray.
If you print something after printing on the paper whose size
is smaller than the actual document size, the back of the next
output might get dirty.
If you continuously print data that contains extremely small
amount of words or images in the printable area, the printed
side of the page could be a hazy gray. Adjust the image densi-
ty. See P.99 “Making Printer Settings with the Operation Panel”.
amount of words or images in the printable area, the printed
side of the page could be a hazy gray. Adjust the image densi-
ty. See P.99 “Making Printer Settings with the Operation Panel”.
Image quality varies when
printing on thick paper or on
OHP transparencies.
printing on thick paper or on
OHP transparencies.
Switch to Thick Paper mode.
• When toner is not fused enough, set it to “On”.
• When the image is blurred, set it to “----”.
Some parts of the print image
are not clear.
are not clear.
Make the image density darker.
See P.99 “Making Printer Settings with the Operation Panel”.
See P.99 “Making Printer Settings with the Operation Panel”.
If Toner Saving mode is selected using the operation panel,
the whole image gets lighter.
the whole image gets lighter.
The print image is not clear.
Due to a sudden change in temperature, condensation might
appear inside the printer, reducing print quality. If this oc-
curs, when you move the printer from a cold room to a
warmer room, do not use the printer until it acclimatizes to
the temperature.
appear inside the printer, reducing print quality. If this oc-
curs, when you move the printer from a cold room to a
warmer room, do not use the printer until it acclimatizes to
the temperature.
Nothing is printed on the paper. Check if the tape of the toner cartridge is completely removed.
Be sure to remove the tape completely when replacing the ton-
er cartridge. See P.88 “Replacing the Toner Cartridge”.
er cartridge. See P.88 “Replacing the Toner Cartridge”.
Note
❒ If the power switch is turned on with the tape still at-
tached to the toner cartridge, the printer might be dam-
aged.
aged.
Multiple pages are fed through
the printer at once.
the printer at once.
Clean the friction pad if it is dirty. See P.91 “Cleaning the Fric-
tion Pad”.
tion Pad”.
Remove all paper from the tray and fan it gently to get air be-
tween the sheets. After that, load it back into the tray.
tween the sheets. After that, load it back into the tray.
The image is printed on the re-
verse side of the paper.
verse side of the paper.
Set the paper the other way up.