Ricoh ap2600 用户指南

Configuring the Protocols

17

Follow these instructions to configure the Network Interface Board and Win-
dows 2000 to use the TCP/IP protocol and IPP.

Configure the printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is ac-

tive.)

• Assign an IP address and make other settings required for using the TCP/IP

protocol.

Reference
For more information about how to make the above settings, see the "Setup
Guide" that comes with the printer.
If DHCP is used to assign IP addresses, see P.97 “When Using DHCP”.

❒ After setting the IP address, use the ping command to confirm that it has been

set correctly.

A

Click [Start], point to [Programs], point to [Accessories] and then click [Com-
mand Prompt]

.

B

Type the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message appears.
Request timed out.

Follow these steps to configure a Windows 2000 computer to use the TCP/IP
protocol.

A

B