Ricoh ap2600 用户指南
NetWare 4.x, 5 - Advanced Settings
61
4
Setting Up as a Print Server
Important
❒ You can set up the print server using the NDS or Bindery mode in NetWare
4.x, 5. The following procedure is for setting up the print server using the
NDS mode in NetWare 4.1. When you set up the print server using the Bind-
ery mode, use the NIB Setup Tool Wizard.
NDS mode in NetWare 4.1. When you set up the print server using the Bind-
ery mode, use the NIB Setup Tool Wizard.
Note
❒ If you use Pure IP in NetWare 5, follow the procedure on P.63 “Using Pure IP
A
Log on to the file server as an Admin or an Admin equivalent.
B
Run the NIB Setup Tool.
Reference
⇒ P.50 “Running the NIB Setup Tool”
⇒ P.50 “Running the NIB Setup Tool”
C
Click [Property Sheet] and click [OK].
The [Browse] dialog box of the Network Interface Board appears.
The [Browse] dialog box of the Network Interface Board appears.
D
Click [IPX protocol].
E
Click the IPX address of the Network Interface Board which is to be config-
ured, and click [Next >].
ured, and click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see a network configuration page to confirm the MAC address (Network
Address).
Address).
F
Confirm that the MAC address and IPX address are correct, and click [Fin-
ish]
ish]
.
The [NIB Setup Tool] window appears.
G
Click [Configure].
The property sheet appears.
The property sheet appears.
H
Click the [General] tab, and type the name of the print server into the [Device
Name]
Name]
box.