Ricoh ap2600 用户指南
Installing Options
32
2
Installing the 1394 Interface Unit
A
Check the contents of the box for
the following items:
• 1394 Interface Unit
• 1394 interface cable (6 pin x 4
the following items:
• 1394 Interface Unit
• 1394 interface cable (6 pin x 4
pin)
• 1394 interface cable (6 pin x 6
pin)
• Installation Guide
B
Be sure to check the following
points:
• The power switch is turned off.
• The power cord is unplugged
points:
• The power switch is turned off.
• The power cord is unplugged
from the wall outlet.
• The interface cable is un-
plugged from the printer.
Note
❒ If the Duplex Unit is not in-
stalled, go to step
D.
C
If the Duplex Unit is installed,
push down the lever on right side
(
push down the lever on right side
(
A
A
A
A) and pull it out until the Du-
plex Unit stops (
B
B
B
B).
D
Use a coin to remove the two
screws.
screws.
Note
❒ These screws are used again in
step
N.
E
Pull out the handle of the control-
ler board.
ler board.
F
Pull the handle and slide the con-
troller board out.
troller board out.
G
Place the controller board on a flat
surface.
surface.
Zcex320j.eps
ZCEX280J.eps
Zcex371j.eps
Zcex261j.eps