Ricoh ap1400 用户手册
Type 2 Printer: Installing Options
23
2
sistance before popping into
place.
place.
Note
❒ Use a coin to reattach the screws
E
Loop the network interface cable
and attach the ferrite core as
shown in the illustration.
and attach the ferrite core as
shown in the illustration.
Note
❒ The network interface cable
loop should be about 15 cm (6")
(
(
A) from the end of the cable
(on the end closest the printer).
The ferrite core at the end of the
cable should be a ring type fer-
rite core.
The ferrite core at the end of the
cable should be a ring type fer-
rite core.
F
Attach the network interface ca-
ble to the jack on the board as
shown in the illustration.
ble to the jack on the board as
shown in the illustration.
G
Connect the other end of the net-
work interface cable to the net-
work.
work interface cable to the net-
work.
H
Plug the printer's power cord
back into the wall outlet and turn
on the printer's power switch.
back into the wall outlet and turn
on the printer's power switch.
The configuration page of the net-
work interface board will be print-
ed automatically. Check the
configuration of the network inter-
face board with it.
work interface board will be print-
ed automatically. Check the
configuration of the network inter-
face board with it.
Important
❒ After installing the network in-
terface board properly, set up
the printer's network environ-
ment using the operation panel.
See P.25 “Configuring the Printer
for the Network with the Operation
Panel”.
the printer's network environ-
ment using the operation panel.
See P.25 “Configuring the Printer
for the Network with the Operation
Panel”.
Type 2 Printer: Installing the
Memory Unit (SIMM)
Memory Unit (SIMM)
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
TS4P090E
TS3P110E
1
TS4C041E