Ricoh AP400 安装指南
Configuring the Printer for the Network
52
3
IEEE 1394 Configuration
Use this procedure to configure the
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
*1
If DHCP is in use, IP address1394 and
Subnet Mask1394 are automatically
set.
Depending on the protocol you use,
procedures vary. See the following ta-
ble.
procedures vary. See the following ta-
ble.
AAAA
Press
{{{{Menu}}}}.
“Menu” appears on the panel dis-
play.
play.
BBBB
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display “Host
Interface” menu.
CCCC
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
the panel display.
DDDD
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display “IEEE
1394 Setup”.
EEEE
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
the panel display.
Setting Name
Value
DHCP
On
000.000.000.000
Subnet Mask1394
000.000.000.000
IP over 1394
Active
SCSI print
Active
Bidi-SCSI print
On
IP over 1394
Steps
A-J and then
go to steps
O to P
SCSI print
Steps
A-D and then
go to steps
K to P
Enter
Form Feed
Job Reset
On Line
Escape
Menu
Power
Error
Data In
ZKEP020E
Menu:
Host Interface
Host Interface:
I/O Buffer
Host Interface:
IEEE 1394 Setup
IEEE 1394 Setup:
DHCP
Enter
Form Feed
Job Reset
On Line
Escape
Menu
Power
Error
Data In
ZKEP060E