Ricoh CL3000 安装指导
Bluetooth Interface Unit Type A
33
1
DDDD
While holding the handle, pull
out the controller board slowly.
out the controller board slowly.
EEEE
Remove USB2.0 Interface Unit.
Note
❒ The removed screws will be
used in step
G
❒ Lift the end of USB2.0 Interface
Unit (
A), and then remove it
from the controller board (
B).
FFFF
Attach the Bluetooth Interface
Unit. Insert the end of the Blue-
tooth Interface Unit to the open-
ing (
Unit. Insert the end of the Blue-
tooth Interface Unit to the open-
ing (
A
A
A
A), and then push down
until it clicks (
B
B
B
B).
Confirm that the Bluetooth Inter-
face Unit is firmly connected to the
controller board.
face Unit is firmly connected to the
controller board.
GGGG
Fasten the Bluetooth Interface
Unit on the controller board using
the screws removed in step
Unit on the controller board using
the screws removed in step
EEEE
.
HHHH
Insert the card slowly into the
Bluetooth Interface Unit with its
side labeled "INSERT" facing up
until it stops.
Bluetooth Interface Unit with its
side labeled "INSERT" facing up
until it stops.
ZHBP020E
ZHBPB460E
ZHBP450E
1
2
ZHBP190E
1
2
ZHBP200E
ZHBP530E
AresPGBOptionSetup-F_FM.book Page 33 Friday, July 26, 2002 1:11 PM