Electrovoice sxa360 用户手册
ELECTRO-VOICE
®
SxA360 Owners Manual
6
Using SxA360’s as Floor Monitors
· The SxA360 is perfect for use as a powered floor monitor.
· The F200 adapters are necessary to convert the SxA360 into a monitor and are shipped with the
· The F200 adapters are necessary to convert the SxA360 into a monitor and are shipped with the
speaker. To install the adapters, simply insert them into the speaker (See Figure 2 below). The
F200 adapters can be easily removed by pulling in the opposite direction.
F200 adapters can be easily removed by pulling in the opposite direction.
· The F200 Monitor Foot kit contains two plastic feet.
· The F200 is used with any 12-inch Sx or SxA speaker enclosures.
· Insert the feet firmly into the holes in the rear cabinet (See Figure 2).
· Remove the F200 monitor feet by pulling in the opposite direction.
· The F200 is used with any 12-inch Sx or SxA speaker enclosures.
· Insert the feet firmly into the holes in the rear cabinet (See Figure 2).
· Remove the F200 monitor feet by pulling in the opposite direction.
CAUTION: The F200 monitor feet protrude from the enclosure. Care should be taken
when moving the enclosure, since damage to the feet or enclosure might occur if the
system is dropped or slid across a rough surface. It is recommended that the feet be
removed for transport.
when moving the enclosure, since damage to the feet or enclosure might occur if the
system is dropped or slid across a rough surface. It is recommended that the feet be
removed for transport.
O-Ring Location
Monitor Foot
Permanent Screw
Location
Location
Figure 2:
Installing the F200 Monitor Foot on the SxA360 Speaker