Haier 2hum18ha03 用户手册
Parts and Functions
Cooling
Indoor
Maximum:D.B/W.B
32
o
C/23
o
C
24
o
C/18
o
C
-7
o
C/-8
o
C
43
o
C/26
o
C
18
o
C
27
o
C
15
o
C
18
o
C/14
o
C
Maximum:D.B/W.B
Minimum:D.B
Maximum:D.B
Minimum:D.B
Minimum:D.B
Maximum:D.B
Minimum:D.B
Minimum:D.B/W.B
Maximum:D.B/W.B
Minimum:D.B/W.B
Outdoor
Indoor
Outdoor
Heating
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similar qualified person. The type of connecting wire is H05RN-F or H07RN-F.
3. If the fuse on PC board is broken please change it with the type of T.3.15A/250V.
4. The distance between the indoor unit and the floor should be more than 2m.
5. The wiring method should be in line with the local wiring standard.
6. After installation, the power plug should be easily reached.
7. The waste battery should be disposed properly.
8. The appliance is not intended to use by young children or infirm persons without supervision
9.Young children should be supervised ensure that they do not play with the appliance.
10.The appliance must be installed on strong enough supporter.
11 .The wiring diagram is attached inside the machine.
or a similar qualified person. The type of connecting wire is H05RN-F or H07RN-F.
3. If the fuse on PC board is broken please change it with the type of T.3.15A/250V.
4. The distance between the indoor unit and the floor should be more than 2m.
5. The wiring method should be in line with the local wiring standard.
6. After installation, the power plug should be easily reached.
7. The waste battery should be disposed properly.
8. The appliance is not intended to use by young children or infirm persons without supervision
9.Young children should be supervised ensure that they do not play with the appliance.
10.The appliance must be installed on strong enough supporter.
11 .The wiring diagram is attached inside the machine.
The machine is adaptive in following situation
1. Applicable ambient temperature range:
1. Applicable ambient temperature range:
4
1
3
.For the unit H2SM-18HC03/R2
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when
starting the EQUIPMENT.This can influence other equipment (eg. Blinking of a lamp).
If the MAINS-IMPEDANCE Zmax<0.199 OHM, such disturbances are not expected. (In case
of need, you may contact your local supply authority for further information.)
12. A breaker should be incorporated into fixed wiring. The breaker should be all-pole switch
and the distance between its two contacts should be not less than 3mm.