Newco akh ap 操作指南

 

1) 

Place filter into brew basket. 

 

2) 

Put the proper amount of coffee into the filter. 

 

3) 

Slide the brew basket into holder. 

 

4) 

For pump style airpots, remove the pump stem. Place the empty dispenser into position below the brewbasket. 

 
5) 

Raise the top evaporation cover and pour ONE pour pitcher of water through the pour-in screen into basin. 

 
6) 

The brewer will begin to brew as the water level in the basin rises and activates the internal float switch.  The brew cycle 

 

may be canceled by turning the master switch located on the rear of the brewer to the off position.  NOTE: Never pour hot 

 

water into the brewer.  This brewer features a European style brewing system which heats only the water for coffee when 

 

you pour it into the brewer.  This type of system does not have a tank to store hot water.  Do not overfill unit by pouring 

 

in more than one decanter of water at a time. 

 

7) 

The heating light on the front of the brewer indicates the operation of the internal brewing mechanism. Hot water will be 

 

delivered through the sprayhead.  This distributes the hot water evenly over the coffee bed within the brew basket.  The 

 

coffee brew will drain from the brew basket into the decanter below. 

 

8) 

The unique thermal brew system takes a little longer to brew than tank systems, which allow the stored water to 

 

become stale, but the result is better tasting and hotter coffee. 

 

9) 

To clean brew basket simply remove from brew rails and dump filter into waste basket. The brewing process, as 

 

described above, can now be started again. 

 

 

Is it plugged in? 

 

Is there water in the receiving pan?  Water activates the float switch, allowing the unit to brew. 

 

Is the master switch located on the rear of the brewer in the ON position?