Frigidaire FARE4044MW 用户指南

6

Clean the lint fi lter after every load.

Í

Over-drying can cause wrinkles, shrinkage, lint, 

harshness and a build up of static electricity.

Í

If a setting is not available for the cycle selected, the 

indicator will not light.

•  Load items loosely. The average wet load will 

fi ll the drum 1/3 to 1/2 full. Items need room to 

tumble freely for even drying and less wrinkling.

•  If desired, place a dryer fabric softener sheet on 

top of the load at the beginning of the cycle.

•  To save energy and time and avoid uneven drying 

and wrinkling, do not overload the dryer.

•  When drying large items, dry only two or three 

items at a time. Fill out the load with small and 

medium sized items.

•  For delicate or very small loads, add two or three 

similar items to improve tumbling action.

•  Adjustments made to a cycle will be remembered and 

recalled each time that cycle is selected in the future.

•  Turn the cycle selector knob in either direction to 

select the cycle desired.

•  The estimated drying time for Auto Dry cycles or 

the actual drying time for Timed Dry cycles will be 

displayed.

•  A suitable drying temperature, dryness level and op-

tions will automatically be indicated for the cycle select-

ed. See the “Dryer Settings Chart” for more details.

•  To change the drying temperature and dryness 

level, press the temp or dryness level buttons to 

scroll to the desired settings.

•  To select or delete an option, press options; then, 

while the indicator is blinking, press select. The 

indicator will light when the option has been se-

lected. It will no longer be lighted when the option 

has been deleted.

•  Close the dryer door. The dryer will not operate with 

the door open.

•  Push in or turn the cycle selector knob or press any 

option buttons to “wake” the dryer. You will hear 

three beeps to indicate dryer is ready to operate.

•  After making your selections, push in the selector 

knob to start the cycle. You will hear one beep before 

the drum begins to rotate.

• Select delay start to delay the beginning of the 

cycle, if desired.

•  To add or remove items when the dryer is running, 

push in the cycle selector knob to pause the cycle 

and open the door. Opening the door with a cycle 

running will also pause the cycle. You will hear two 

beeps. Allow the drum to come to a complete stop 

before reaching inside. Add or remove the item, 

close the door and push in the selector knob again, 

continuing the current cycle.

•  To cancel a running cycle, push in and hold the 

cycle selector until the dryer discontinues running.

•  A signal will sound at the end of the cycle if the 

chime option has been selected.

To return to factory settings, 

press these two buttons at 

the same time and hold until 

the signal sounds.

Í

If drying a single large or bulky item, such as a 

comforter, remove the item part way through the cycle 

and turn it “inside out” to maximize drying effectiveness. 

Place item back in dryer and re-start cycle.