Scitec 5s-c 用户手册
Unpacking your telephone:
Verify that the package contains the following supplied items:
• Telephone base unit
• Handset
• Coiled handset cord
• Straight line cord
• This user guide
Assembling your telephone:
Verify that the package contains the following supplied items:
• Telephone base unit
• Handset
• Coiled handset cord
• Straight line cord
• This user guide
Assembling your telephone:
If you will be wall-mounting your Aegis-5Sc, it is best to do the
conversion before connecting the handset and line cords. If you will
using the 5S-c on a desktop, skip to the section “Attaching the handset”
using the 5S-c on a desktop, skip to the section “Attaching the handset”
Wall-mounting your telephone:
1) The wall/desk handset clip located on the front of the phone
1) The wall/desk handset clip located on the front of the phone
directly above the speaker grill. In its wall-mount position, the clip
extends up to hold the handset in place. Gently pull it up and turn
½ turn to change from desk to wall mount. This clip is
spring-loaded and not removable, so that it cannot be lost.
extends up to hold the handset in place. Gently pull it up and turn
½ turn to change from desk to wall mount. This clip is
spring-loaded and not removable, so that it cannot be lost.
2) Turn the telephone over so the telephone face is down.
3) Connect line cord to the jack on rear of phone. Route the line cord
3) Connect line cord to the jack on rear of phone. Route the line cord
through the line cord channel. Pass the other end of the line cord
through the rectangular hole in the back of the mounting bracket.
Coil up any excess line cord length for placement between the
through the rectangular hole in the back of the mounting bracket.
Coil up any excess line cord length for placement between the
telephone and the wall-mounting bracket.
4) Position the wall-mounting bracket so that the Scitec “Sun” designs
are toward the front edge of the phone and the four retaining tabs
on the bracket line up with the slots in the bottom of the phone.
Firmly press on the bracket to snap it into place.
on the bracket line up with the slots in the bottom of the phone.
Firmly press on the bracket to snap it into place.
5)
Connect the free end of the RJ-11 line cord to the wall jack. Hold
telephone in front of the 2 mushroom shaped mounting posts on the
wall jack plate. Line up keyholes on wall-mounting bracket with
posts. After engaging wall-mounting bracket with posts, slide
telephone down slightly. When properly installed, the telephone
will be firmly attached to the wall.
telephone in front of the 2 mushroom shaped mounting posts on the
wall jack plate. Line up keyholes on wall-mounting bracket with
posts. After engaging wall-mounting bracket with posts, slide
telephone down slightly. When properly installed, the telephone
will be firmly attached to the wall.
Attaching the handset:
Connect the supplied coiled handset cord between the jack on the
end of handset and the jack marked with a “handset” symbol on the
left side of the telephone base unit. Place the handset on the telephone
base unit or if wall-mounted, hang it on the desk/wall-mount clip to
depress the hook switch.
left side of the telephone base unit. Place the handset on the telephone
base unit or if wall-mounted, hang it on the desk/wall-mount clip to
depress the hook switch.
Installing your telephone:
For desktop use, connect the supplied straight modular cord
between the jack on the rear of telephone and the telephone system
wall jack. Lift the handset, and a dial tone should be heard if the
telephone is correctly installed.
wall jack. Lift the handset, and a dial tone should be heard if the
telephone is correctly installed.