Frigidaire fak127p1v 安装指导
Installation Instructions
for Slider Casement
NOTE:
These instructions describe installation
in a typical wood framed window with a wood
SLIDE-BY sash, or installation in a metal
C A S E M E N T w i n d o w. M o d i f i c a t i o n m a y b e
necessary when installing in windows made
differently than those shown in these instructions.
SLIDE-BY sash, or installation in a metal
C A S E M E N T w i n d o w. M o d i f i c a t i o n m a y b e
necessary when installing in windows made
differently than those shown in these instructions.
1
A high window accessory kit EA 103W is available
for window heights up to 62" (1575mm).
for window heights up to 62" (1575mm).
TABLE OF CONTENTS
SUBJECT PAGE
Meeting Electrical Requirements 1
Electrical Connection 2
Preparing for Installation 2
Sliding Window Installation 4
Casement Window Installation 5
Installation in Wood Window 6
Meeting Electrical Requirements 1
Electrical Connection 2
Preparing for Installation 2
Sliding Window Installation 4
Casement Window Installation 5
Installation in Wood Window 6
Meeting Electrical Requirements
WARNING
WARNING
!
Electrical Shock and Personal Injury Hazard
Electrical ground is required on this appliance.
DO NOT ground to a gas line.
If cold water pipe is interrupted by plastic,
DO NOT ground to a gas line.
If cold water pipe is interrupted by plastic,
non-metallic gaskets, or other insulating.
Materials, DO NOT use for grounding.
Materials, DO NOT use for grounding.
Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.
grounded.
DO NOT modify power supply cord plug. If it
does not fit outlet, have a proper outlet
installed by a qualified electrician.
installed by a qualified electrician.
DO NOT have a fuse in the neutral or grounding
circuit. A fuse in the neutral, or grounding
circuit could result in an electrical shock.
circuit could result in an electrical shock.
DO NOT use an extension cord with this
appliance.
Failure to follow these instructions could result
electrical shock, serious injury, or death.
electrical shock, serious injury, or death.
OBSERVE ALL LOCAL GOVERNING CODES
AND ORDINANCES.
AND ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE
THE POWER SUPPLY CORD GROUNDING PRONG.
THE POWER SUPPLY CORD GROUNDING PRONG.
NOTE: If codes permit, and a separate grounding
wire is used; it is recommended that a qualified
electrician determine that the grounding path is
adequate and not interrupted by plastic, non-metallic
gaskets, or other insulating materials.
wire is used; it is recommended that a qualified
electrician determine that the grounding path is
adequate and not interrupted by plastic, non-metallic
gaskets, or other insulating materials.
RECEPTACLE WIRING
Receptacle wiring should be a minimum of 14 gauge.
Use copper wire only. It is your responsibility to
provide proper and adequate receptacle wiring,
installed by a qualified electrician.
Receptacle wiring should be a minimum of 14 gauge.
Use copper wire only. It is your responsibility to
provide proper and adequate receptacle wiring,
installed by a qualified electrician.
ELECTRICAL REQUIREMENTS
A 115 volt (103 minimum, 126 maximum), 60 Hertz,
AC only, 15 ampere fused electrical supply is
required. A time delay fuse or time delay circuit
breaker is also required. A separate circuit, serving
only this appliance, MUST be provided.
A 115 volt (103 minimum, 126 maximum), 60 Hertz,
AC only, 15 ampere fused electrical supply is
required. A time delay fuse or time delay circuit
breaker is also required. A separate circuit, serving
only this appliance, MUST be provided.
P/N