Frigidaire fgf326wgtb 用户指南

12

1. Remove burner grates and spillover bowls (if equipped). Set aside.

2. Grasp the sides of the cooktop and then lift from the front.

3. Lift the top high enough to allow the support rods to snap into place. The

Lift-up rods will support the top in its raised position.

4. Clean underneath using hot, soapy water and a clean cloth; then, dry.

5. Lower the top gently by pushing back on each rod. This will release the

notched support. Hold the range top and slide the range top down into the

range frame.

Your model will have one of the two burners types shown below. Follow the

instructions that correspond with the burners on your range.

1. Remove shipping screws with a Phillips® Head screwdriver. See illustration

for screw locations.

2. Tilt the burner at the end closest to the support bar until the locator tab is

released (front burners tilt right, rear burners tilt left). Move it toward the

back of the range. This will separate it from the gas valve at the front of the

range.

1. Slide the burner tube over the gas valve at the front of the range (front

burners fit over the right valve, rear burners fit over the left valve on each side

of the range).

2. Tilt burner so that the locating tab will slide into the slot on the support bar.

Make sure burners are properly seated on support bar and are level.

3. Replace shipping screws if desired.

DO NOT drop or bend the rangetop

 DO NOT turn the burners

on when the cooktop is raised for

cleaning.  Be sure that the top is

completely lowered and securely in place

before turning on the burners.