Logic Controls KB5000 用户手册
16
KB5000 User Manual Rev. 2
MODIFYING PROPERTIES OF THE KEYBOARD
After key definitions are finished, click on the item Configuration→Config KB Properties on
the menu bar or click on the “Modify Properties” icon on the toolbar to set or change
programmable keyboard features.
Config OPOS/JPOS
the menu bar or click on the “Modify Properties” icon on the toolbar to set or change
programmable keyboard features.
Config OPOS/JPOS
•
You may configure the keyboard according to which standard, OPOS/JPOS, your
POS application is running.
POS application is running.
Send break-code for scan-code mode key
•
Enables the transmission of break codes for each scan codes programmed into
the keyboard. A break code is a code that is sent to tell the PC that the key is
being released.
the keyboard. A break code is a code that is sent to tell the PC that the key is
being released.
Enable beep when a key typed
•
Enables the entire keyboard from beeping when any key is depressed.
No beeping if a key is not defined
•
If a key has no definition, it will not beep when depressed.
Translate code set #2 for PC/AT
•
Enables the output of the keyboard to be translated into AT scan code.
Use <ALT> +number key to make ASCII code
•
Enables the use of ALT key along with the numeric keypad to generate codes for
definitions programmed in ASCII mode. This will allow output of ASCII characters
in the specified upper or lower case independent of the Caps Lock status and
Shift key status.
definitions programmed in ASCII mode. This will allow output of ASCII characters
in the specified upper or lower case independent of the Caps Lock status and
Shift key status.
Enable typematic for scan code
•
Enables keys programmed with scan code mode to repeat key outputs as long
as the key remains depressed.
as the key remains depressed.
Enable typematic for ASCII code
•
Enables keys programmed with ASCII code mode to repeat character output as
long as the key remains depressed.
long as the key remains depressed.
Inter-character delay (ms)
•
The time delay between characters can be adjusted from 1 millisecond to 250
milliseconds. This delay is set for all key strokes or characters programmed into
the keyboard. This feature should not be confused with the Interstring Delay
feature.
milliseconds. This delay is set for all key strokes or characters programmed into
the keyboard. This feature should not be confused with the Interstring Delay
feature.