Microtek 722s 用户指南

17

A VESA-compliant arm allows you to mount your monitor on
the wall.

The accepted arm specifications for the monitor are:

• Compatibility with the VESA standard

• Required gap of 100mm x 100mm between  the screw holes

for the arm to be attached

Caution:

• Do not bend the cable too much or add extension cords, as

this may cause malfunction.

• Please refer to the documentation that came when you

purchased the monitor arm, while following the steps below
to install the arm.

• Do not get your fingers pinched between the display and

stand or let the stand drop, as this may cause injury.

• The arm is likely to fall off or break off after being attached to

the monitor.

To install the arm, follow the steps below:

1. Disconnect the cables from the monitor.

2. Place and spread a soft cloth on a flat, stable surface table.

3. Gently place the monitor screen-side down on the table.

4. Remove the cover from the rear

of the monitor by pressing the
( ) icon located at the two sides
of the cover, as shown in the
illustration.