Microtek jtx v7s 用户指南

This device complies with part 15 of the FCC Rules. Operation is subject 
to the following two conditions: 

1.  this device may not cause harmful interference, and 
2.  this device must accept any interference received, including interfer-

ence that may cause undesired operation. 

This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures: 

•  Reorient or relocate the receiving antenna. 
•  Increase the separation between the equipment and the receiver. 
•  Connect the equipment into an outlet different from that to which 

the receiver is connected. 

•  Consult the dealer or an experienced radio/TV technician for help. 

To comply with the limits for an FCC Class B computing device, always 
use the shielded signal cord supplied with this unit. 

The Federal Communications Commission warns that changes or modifi-
cations of the unit not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.