Nortel 4526T-PWR 用户指南
64
Chapter 2 Configuring Quality of Service (QoS) with the CLI
Parameter
Description
name <WORD>
Assigns a name to a QoS action with the designated
action ID. Enter the name for the action; maximum is
16 alphanumeric characters
action ID. Enter the name for the action; maximum is
16 alphanumeric characters
drop-action<enable |
disable | deferred-pass>
disable | deferred-pass>
Specifies whether packets are dropped or not:
•
enable--drop the traffic flow
•
disable--do not drop the traffic flow
•
deferred-pass--traffic flow decision deferred to
other installed policies
other installed policies
Default is deferred pass.
ATTENTION
If you omit this parameter, the default value
applies.
applies.
update-dscp <0-63>
Specifies whether DSCP value are updated or left
unchanged; unchanged equals ignore. Enter the
6-bit DSCP value; range is 0 to 63.
unchanged; unchanged equals ignore. Enter the
6-bit DSCP value; range is 0 to 63.
Default is ignore.
update-1p<0-7>
Specifies whether 802.1p priority value are updated
or left unchanged; unchanged equals ignore:
or left unchanged; unchanged equals ignore:
•
ieee1p--enter the value you want; range is 0 to 7
•
use-egress--uses the egress map to assign value
•
use-tos-prec--uses the type of service
precedence to assign value.
precedence to assign value.
Default is ignore.
Nortel Ethernet Routing Switch 4500 Series
Configuration — Quality of Service
NN47205-504 (322816-
B
)
03.01
Standard
5.1
23 November 2007
Copyright © 2007, Nortel Networks
.