Nortel 4526T-PWR 安装指南

Setting IP parameters for the Nortel Ethernet Routing Switch 4500 Series

The Read-Write Community String prompt line appears

Please provide the Read-Write Community

String[**********]:*******

The confirm Read-Write Community String prompt line appears

Please confirm the Read-Write Community

String[**********]:*******

The Quick Start VLAN prompt line appears

Please provide the Quick Start VLAN <1-4094> [1]:

The Basic Switch parameters configuration confirmation appears

Basic switch parameters have now been configured and

saved.

—End—

ATTENTION

Nortel Ethernet Routing Switch 4500 Series console port supports Nortel CLI only.
When the switch is set to factory default parameters, the CLI Quickstart displays.

Setting IP parameters using the console port and CLI

If the switch is configured beyond factory default settings, perform the
following procedure to set IP parameters using the console port and
Command Line Interface (CLI):

Step

Action

Connect a terminal to the console port of the switch. Any terminal
or PC with an appropriate terminal emulator can be used as the
management station. See

"Setting IP parameters using the console

port and CLI Quickstart" (page 47)

Set the terminal protocol on the terminal or terminal emulation
program to VT100 or VT100/ANSI.

Connect to the switch using the terminal or terminal emulation
application.

After the Nortel banner appears, press

CTRL + Y

to display the

CLI prompt.

To enter the Global Configuration command mode, use the

enable

command.

Nortel Ethernet Routing Switch 4500 Series

Installation Guide

NN47205-300 (322811-B)

03.01

Standard

5.1

19 November 2007