Nortel 2526T 用户指南
Securing your network
81
Table 39
show mac-security command parameters and variables
show mac-security command parameters and variables
Parameters and
variables
variables
Description
config
Displays the general BaySecure configuration.
mac-address-t
able [address
<macaddr>]
Displays contents of the BaySecure table of allowed
MAC addresses:
MAC addresses:
•
address
specifies a single MAC address to display;
enter the MAC address.
port
Displays the BaySecure status of all ports.
security-lists
Displays the port membership of all security lists.
mac-da-filter
Displays MAC DA filtering addresses.
shows sample
output from the
show mac-security
command.
Figure 10
show mac-security command output
show mac-security command output
mac-security command
The
mac-security
command modifies the BaySecure configuration. The
syntax for the
mac-security
command is:
mac-security [disable|enable] [filtering {enable|disable}]
[intrusion-detect {enable|disable|forever}] [intrusion-timer
<1-65535>] [learning-ports <portlist>] [learning {enable
|disable}]|mac-address-table|mac-da-filter|security list
[snmp-lock {enable|disable}] [snmp-trap {enable|disable}]
The
mac-security
command is executed in the Global Configuration
command mode.
describes the parameters and variables for the
mac-security
command.
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B)
02.01
Standard
4.1
19 November 2007
Copyright © 2007, Nortel Networks
.