Novation remote25sl 用户指南

• 

32

•

The Template Edit ‘MMC’ Pages

The following Menu pages are available if Control Type on menu page 1 is set to ‘MMC’. These are only
available if the control being edited is a button and would typically be used to control a sequencer or
recording device :

Sets the Device ID number for the MMC message.

Defines the type of MMC message transmitted. The available types are Stop, Play, F Fwd, Rewind &
Record (Record Strobe).

When a TRANSPORT button sends a MMC message, the following display is shown on-screen while the
button is held down :

Stop
1   MMC   1 U12

This is similar to the display shown when other types of MIDI information are transmitted by a control (see
page 12). Shown on the top line is the type of MMC command defined, while on the bottom line at the left
is the MMC number of the command, followed by the usual MIDI message type, MIDI channel and port
routing displays. 

Determines which MIDI / USB port is used to send the MIDI information generated by touching the control.

Eight different combinations of output ports can be selected, with any multiple combination possible. A ‘U’
shown on the display indicates the MIDI will be sent from the USB port, a ‘1’ that the MIDI OUT (1) port will
be used and a ‘2’ indicates that the MIDI OUT (2) port will be used.

Note : MMC commands are not transmitted when a ‘snapshot’ is activated.

2

Device ID:

0…127

3

MMC Command:

Play…Stop

4

MIDI Ports:

---…U12