Nortel 1010 用户指南
158 Chapter 8 Configuring IPSec mobility and persistent mode
NN46110-500
IPSec mobility performs at higher level than physical adapters. As a result, the
PC on which the Nortel VPN Client runs can change between any physical
adapters (wireless or wireline) and roaming will continue to work as long as
there is IP connectivity between the Nortel VPN Router and the client with the
newly acquired address/interface. If you have problems with roaming to
specific interfaces, make sure that you can establish an initial connection with
that adapter to prove that there is IP connectivity.
PC on which the Nortel VPN Client runs can change between any physical
adapters (wireless or wireline) and roaming will continue to work as long as
there is IP connectivity between the Nortel VPN Router and the client with the
newly acquired address/interface. If you have problems with roaming to
specific interfaces, make sure that you can establish an initial connection with
that adapter to prove that there is IP connectivity.
To configure the Nortel VPN Router using CLI, you need to either telnet to the
Nortel VPN Router or connect to it through the Serial Interface > option L on the
menu.
Nortel VPN Router or connect to it through the Serial Interface > option L on the
menu.
Enter the privileged mode:
CES>enable
Password:
Enter configuration mode:
CES#configure terminal
Enter configuration commands, one per line. End with Ctrl/z.
CES(config)#
To install advanced routing license:
CES(config)#license install ar <license key>
To verify the license has been installed:
CES(config)#show license
Advanced Routing Installed
Contivity Stateful Firewall Not installed
Data Link Switching Not installed
To enter a group IPSec configuration mode, for example, for group Base:
CES(config)#group ipsec "/Base"
CES(config-group/ipsec)#