Nortel 1100 安装指导
Chapter 1 Nortel VPN Router 600 option installation 39
Nortel VPN Router Installation — Hardware Options
8
Replace the four Phillips screws that secure the bottom panel to the chassis
(
(
9
Connect the cables to the system ports and to the option card port.
10 Plug the cable attached to the external power supply into the receptacle
labeled “DC Input” on the rear of the VPN Router 600.
11 If necessary, plug the female end of the power cord into the external power
supply pack.
12 Plug the male end of the power cord into a surge protector.
13 Plug the surge protector (or the power cord) into the power outlet.
The VPN Router 600 begins to boot.
Replacing a DIMM
The VPN Router 600 has one slot for a dual inline memory module (DIMM). If
you have a VPN Router 600 with a 64 MB DIMM, you can upgrade system
memory by replacing the installed DIMM with a 128 MB DIMM.
you have a VPN Router 600 with a 64 MB DIMM, you can upgrade system
memory by replacing the installed DIMM with a 128 MB DIMM.
Note: The VPN Router 600 has no power switch. When you connect the
VPN Router 600 to a power supply, the gateway turns on.
VPN Router 600 to a power supply, the gateway turns on.
Caution: Use of a memory module not purchased from Nortel can void
your warranty or your service contract.
your warranty or your service contract.
Note: Nortel ships newer VPN Router 600 gateways with 128 MB of
memory installed. If you purchased your VPN Router 600 after January
2002, your gateway most likely has 128 MB of memory.
memory installed. If you purchased your VPN Router 600 after January
2002, your gateway most likely has 128 MB of memory.