Nortel 5782 用户指南
119557-A Rev. 00
C-1
Appendix C
Network Information Worksheet
You use the Quick-Start installation script (install.bat) to establish an initial IP
network interface between the Model 5782 VNR and a Site Manager workstation.
You can then use Site Manager to refine your configuration.
network interface between the Model 5782 VNR and a Site Manager workstation.
You can then use Site Manager to refine your configuration.
Use the Quick-Start installation script to add ATM to the router by:
•
Defining the physical link
•
Defining an ATM service record
•
Creating an ATM circuit
•
Adding the initial virtual circuit to the service record (PVCs only)
•
Enabling the IP protocol on the ATM service record
Sample Quick-Start Network Setup
Before running the install.bat script, you must first connect a terminal or PC to the
Model 5000BH service port. In addition, you must also have a Site Manager
workstation residing on the network to fully configure the Model 5782 ATM
backplane interface.
Model 5000BH service port. In addition, you must also have a Site Manager
workstation residing on the network to fully configure the Model 5782 ATM
backplane interface.
shows a sample ATM Quick-Start network setup. The ATM
Quick-Start Worksheet examples (
) use the addresses and subnet masks
that appear in this figure.