Nortel 8600 dslam 用户手册
3-1
8600-A2-GN20-20
October 1997
Initial Setup Instructions
3
Setting the IP Address and Subnet Mask on the MCC
for Remote Configuration
for Remote Configuration
You can fully configure the MCC and DSL cards at the Central Office (CO) using
the console terminal. However, if you want to perform remote card configuration
from a network management workstation via a telnet session, you must set the IP
address and subnet mask of the MCC card using a terminal connected to the
DSLAM’s serial console interface
the console terminal. However, if you want to perform remote card configuration
from a network management workstation via a telnet session, you must set the IP
address and subnet mask of the MCC card using a terminal connected to the
DSLAM’s serial console interface
before you can configure the cards remotely.
This section describes how to set the IP address and subnet mask of the MCC
card. Refer to the
card. Refer to the
HotWire DSLAM for 8540 and 8546 DSL Cards User’s Guide
for detailed information on how to completely configure the MCC and DSL cards.