Nortel 4134 安装指导
Interface modules for the Secure Router 4134
37
ATTENTION
You must install the Secure Router 4134 PoE power supply to take advantage
of the PoE capabilities.
of the PoE capabilities.
Table 20
Cable and connectors
Cable and connectors
Port
Connector
Recommended
cable type
cable type
Minimum
cable length
cable length
Maximum
cable length
cable length
10Base-T (full-
or half-duplex),
100Base-TX (full
duplex)
or half-duplex),
100Base-TX (full
duplex)
RJ-45
EIA Category 3,
4, or 5 UTP for 10
Mb/s operation.
EIA Category
5 UTP or STP
required for 100
Mb/s operation.
4, or 5 UTP for 10
Mb/s operation.
EIA Category
5 UTP or STP
required for 100
Mb/s operation.
None
328 ft (100 m)
Table 21
Module LEDs
Module LEDs
LED
Description
10/100 BASE-T
PORT STATUS
PORT STATUS
LEDs are integrated into each port.
Status of each interface:
Status of each interface:
•
Off: Link not connected or Link Fail
•
Solid Green: Link established at 10 or 100 Mbps
•
Blinking Green: Receiving/transmitting traffic
GbE Large Module
The 44-port 10/100/1000 Large Module provides 44 Ethernet ports that
each support 10/100/1000 Mbps operation over unshielded twisted pair
(UTP) wiring, as well as two SFP optical ports. Up to 44 ports can be in
use at one time.
each support 10/100/1000 Mbps operation over unshielded twisted pair
(UTP) wiring, as well as two SFP optical ports. Up to 44 ports can be in
use at one time.
The 44-port GbE Large Module provides both Layer 2 switching and Layer 3
routing functionality.
routing functionality.
The following figure shows the 44-port GbE Large Module.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301
01.02
Standard
10.0
7 August 2007
Copyright © 2007, Nortel Networks
.