Nortel 4134 安装指导
Connecting power cables
51
8
Ensure you are in configuration mode, then enter the following
command to set the replacement module to an active state:
command to set the replacement module to an active state:
chassis module <slot> no shutdown
9
To verify the module status, enter:
show chassis
—End—
If you encounter issues activating the replacement interface module, see
Nortel Secure Router 4134 — Troubleshooting (NN47263-700).
Nortel Secure Router 4134 — Troubleshooting (NN47263-700).
Connecting power cables
There are two types of power supply modules available for the Secure
Router 4134:
Router 4134:
•
AC power supply module (standard or PoE) requiring an external AC
power source
power source
•
DC power supply module requiring an external DC power source
Use the procedures in this section to connect AC and DC power cables to a
Secure Router 4134.
Secure Router 4134.
Connecting AC power cables
Average time to install one AC power cable: 1 minute.
CAUTION
ESD
Always wear an ESD-preventative wrist strap when connecting
cables or performing maintenance on a Secure Router 4134.
Ensure that the wrist strap makes contact with your skin.
cables or performing maintenance on a Secure Router 4134.
Ensure that the wrist strap makes contact with your skin.
Prerequisites
•
Ensure you have one or two appropriately rated AC power cords,
dependent on your configuration.
dependent on your configuration.
•
Ensure the power cord or cords are long enough that you can plug the
male end into a standard 110/220 V AC power outlet.
male end into a standard 110/220 V AC power outlet.
Procedure steps
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301
01.02
Standard
10.0
7 August 2007
Copyright © 2007, Nortel Networks
.