Nortel 2350 快速安装指南

NN47250-300 (320655-E

 

Version 02.01)

You can use an IP address list or a hostname list, but not both. If the list contains both types of values, the AP does not 
attempt to use the list.

If you use the host option, you must configure the network’s DNS server with address records that map the hostnames 
in the list to the WSS IP addresses. Valid characters in hostnames are limited to uppercase and lowercase letters, 
numbers, periods (.), and hyphens (–).

After receiving a DHCP, acknowledgement containing a valid string for option 43, a AP sends a unicast message to 
the each WSS in the list, to request a software image and configuration. If the AP does not receive a reply to the 
request after one minute, the AP starts the boot process over with a new DHCP Discover message, this time from AP 
port 2.

No configuration is required on the WSS itself.

Estimated timing: 10 minutes

To access the CLI quickstart wizard, use the following procedure:

Attach a PC to the WSS serial console port, as described in 

.

Enter enable to access the configuration level of the CLI.

The password to gain access to privileged mode is not set. When prompted for the 
password, press Enter to continue.

Note: Be sure to removed the default leading period before entering an 
ASCII IP address. The DHCP configuration will not work correctly if this 
period remains in front of the IP address.

Note: The quickstart wizard places the Ethernet port in VLAN 1. If your 
requires that the Ethernet port be in a different VLAN or tagged, then you 
must manually configure and save those settings using the CLI.