Nortel 2350 参考指南
148 Planning the Nortel WLAN 2300 System
NN47250-102 (320666-G Version 02.01)
3
To optimize the AP count, select Optimize AP Count. This option checks for coverage overlaps and
removes an AP if neighboring APs provide enough coverage to make the AP unnecessary.
removes an AP if neighboring APs provide enough coverage to make the AP unnecessary.
4
Select Compute Power for the areas for which you want to compute power.
5
Click Next. The Compute Power For Progress page appears.
•
If the power computation succeeds, click Finish to see the results.
•
If the power computation fails, click OK in the Optimal Power Computation box, and click
Finish. See
Finish. See
6
To include third-party access points in the network plan, see
To resolve optimal power computation problems
If power levels for one or more coverage areas could not be optimized, show the RF coverage at baseline association and
minimum transmit rates for the coverage areas by doing the following:
minimum transmit rates for the coverage areas by doing the following:
1
In the Show RF coverage using listbox, select how you want to display the coverage:
•
Baseline Association Rate—Coverage is shown based on the AP radio baseline association
rate. The baseline association rate is the typical data rate the radio is expected to support for
client associations. (The baseline association rate is specified during planning, on a coverage
area basis.)
rate. The baseline association rate is the typical data rate the radio is expected to support for
client associations. (The baseline association rate is specified during planning, on a coverage
area basis.)
Note. This option applies only to coverage areas that are configured for coverage,
not capacity. Unless you disabled the option to place APs based on capacity, do
not select the Optimize AP Count option.
not capacity. Unless you disabled the option to place APs based on capacity, do
not select the Optimize AP Count option.